ATAVRRZ200【PDF 17/22 页】KIT DEMO AT86RF230

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录52

13页 14页 15页 16页 [17页]18页 19页 20页 21页

Demonstration Kit User Guide

5-3

5183AZIGB12/07/06

5.2

Reconfiguring

the network

All configurations of the network nodes are performed in the Configure screen on the

Display Board.

Note: This demonstration requires at least two nodes to associate with the PAN Coor-

dinator. This is because the demonstration expects a minimum of one LED

device and one switch device.

With the Configure screen displayed, the functions of the device can be changed by

using the joystick to highlight the devices existing function. When the function is high-

lighted, pressing SW2 will cycle between the available options (Switch or LEDs).

Consult Figure 5-4 through Figure 5-7 and their captions.

The switch functions on the Display Board are shown below.

SW1: Toggles the display between the Configure screen (Figure 5-7) and the

Network Monitor screen (Figure 5-8).

SW2:

1. When the Configure screen (Figure 5-7) is displayed, pressing this button

changes the highlighted function of the device. The functions are:

LED

Switch 1

Switch 2

Switch 3

Joystick: The joystick up and down switch are used to highlight the device function on

the Configure screen (Figure 5-7).

Joystick Push: By pressing down on the joystick, the PAN Coordinator will attempt to

communicate to all devices. If any devices are out of range or become disassociated,

they will be removed from the network table.

5.3

Using the

network

Each RCB has a Test button and three LEDs. Figure 5-9 shows an RCB with all three

LEDs illuminated:

Figure 5-9. RCB Test button

RCB Test button

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式